Re: (ASCEND) Ascend and Cisco Frame Relay

To: bbsadmin@sheltonbbs.com
Subject: Re: (ASCEND) Ascend and Cisco Frame Relay
From: Phillip Vandry <vandry@Mlink.NET>
Date: Thu, 22 Jan 1998 13:38:45 -0500 (EST)
cc: ascend-users@bungi.com
In-reply-to: Your message of "Thu, 22 Jan 1998 10:34:34 EST." <199801221634.KAA08123@mail.sheltonbbs.com>
Sender: owner-ascend-users@max.bungi.com

> I am about the add the Hash codes for the Ascend Max 4048 to allow it 
> to use the Serial WAN port for my Frame Relay.  This Max will need to 
> be set up on a Point to Point connection with a Cisco 2501 router.  
> Has anyone done this with success?  Is there anything I should 
> consider before doing this?  I currently have a Cisco 2501 on the LAN 
> with the MAX, but if the Serial WAN port will work, I would prefer 
> that (eliminates a hub and a Router).  Thanks for any information.

Yes, this works. Keep the number of PVCs under 3 though. We has a few
problems with more PVCs than that.

-Phil
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

Follow-Ups:

Re: (ASCEND) Ascend and Cisco Frame Relay

From: "Kevin A. Smith" <kevin@ascend.com>

References:

(ASCEND) Ascend and Cisco Frame Relay

From: "Butch Evans" <bbsadmin@sheltonbbs.com>

Prev by Date: RE: (ASCEND) Remote Disconnection
Next by Date: RE: (ASCEND) ISDN setup
Prev by thread: (ASCEND) Ascend and Cisco Frame Relay
Next by thread: Re: (ASCEND) Ascend and Cisco Frame Relay
Index(es):
- Main
- Thread