Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
(ASCEND) Pipeline 50 B/Routing
I have a "newbie" question. I am very new to the entire network
routing/bridging world and don't seem to be getting any answers from
ASCEND Tech Support, they are pethetically slow.
I have a office with Novell 3.12 running IPX. I am going to be switching
over to IP but this is an accounting office and I do not dare changing
protocols in the middle of tax season. One of the partners has a Windows
95 machine at home that he would like to be able to dial in from. I
contracted with Bell-Atlantic to install a Centrex ISDN switch for him
to alleviate message unit charges, and purchased a PIPELINE 50 for the
office and a PIPELINE 15 for his home.
Here is the delema;
I assumed that since I would be dialing into a network from a single
machine that routing would be unnecessary and I could just bridge,
however I was not able to see the network. When I enable routing I can
see the network but cannot browse or login. Does any one have a simple
checklist of options that must be enables/disables in order to make each
of these work. This is a very small netowrk (15 nodes). Also when I
enable routing the pipeline 50 with its own unique IPX address that I
assign shows as a Network server, is this correct?
Any insight would be helpful, as I am looking to get this monkey off my
back and learn from the whole miserable affair.
Tim Jabaut
tjabaut@hotmail.com
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>