Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
(ASCEND) TNT hardware configuration question
We would like to use TNT's as large dialin remote access boxes. They
will simply be used to terminate ISDN/v.34/K56Flex calls, and give
them access to our network (either ethernet or FDDI..not sure yet).
So, we just want to load them up with a network card, PRI cards,
and K56 modem cards. I was just wondering if anyone could
either confirm the below numbers, or correct them. Thanks in advance!
(1) MAX TNT chassis 16 slots
- hybrid access module - 1 slot
- (2) PRI modules (accepts 16 PRI's) - 2 slot
- Network card (100baseT/FDDI/whatever) - 1 slot
- (6) 48port 56kbps modem module (288 modems) -12 slots
Max Capacity = 382 lines (using NFAS 1D/8PRI)
Can have up to 288 analog users simultaneous with 94
ISDN users.
Stack a second TNT (we don't use OSPF ;-)....
(1) MAX TNT chassis 16 slots
- hybrid access module - 1 slot
- (1) PRI module (accepts 8 PRI's) - 1 slot
- Network card (100baseT/FDDI/whatever) - 1 slot
- (6) 48port 56kbps modem module (288 modems) -12 slots
Max Capacity = 573 lines (using NFAS - 1D/8PRI)
Have 576 modems, so all users could be analog.
Have one extra slot for another network card, etc, etc.
Any input is greatly appreciated!
___________________________________________________________________________
Joe Pautler, E.I.T. University at Buffalo
CIT/OSS Network Engineering 224 Computing Center
http://www.oss.buffalo.edu/~pautler (716) 645-3536
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>