Re: (ASCEND) diag commands

[Jim Howard <jhoward@lyceum.com>]

At 22:27 1998/02/21 +0100, Rob Dirksen wrote:
>What is the effect of the command nvramclear ? does it reset the unit in
>its "virgin" factory state without affecting the code ic. only clearing
>the configuration.

to do this you'll need to:      fclear
                                nvramclear

to erase both the Flash RAM and NV RAM copies of the config.

>Where do I find more elaborate help on all the diagnostic commands; some
>of the online descritions are pretty cryptic.

as these commands a "intended for use during a support call"
when Ascend Tech support asks you to check a debug output,
there havn't been any real docs on most of the commands...

-Jim H
----
Jim Howard             Sr Network Engineer        Lyceum Internet
jhoward@lyceum.com     http://www.lyceum.com/     404.248.1733     

My PGP Public Key: http://www.lyceum.com/~jhoward/pgp-key.txt
Fingerprint: 7E8B E2BA 1314 2535 CB08  CFF9 119B 7CD3 2488 954D

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

---

• Prev by Date: Re: (ASCEND) VOICE in syslog
• Next by Date: Re: (ASCEND) Stable Ver for max4000's
• Prev by thread: (ASCEND) Re: (PIPELINE) diag commands
• Next by thread: (ASCEND) mrtg, p130 and 5.1Ap9
• Index(es):
  • Main
  • Thread