Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Newbie Question (diagnostics mode?)
Steve Nolan wrote:
]
]I see much discussion of diagnostics mode on Max40XXs, but for the life of me
]I can't seem to figure out where the debug info gets output to? I'm
]specifically looking for help with the modemdiag command on a Max4048,
]5.0Ap11, but any help would be great, even (especially?) an RTFM reply.
The diag is output right to the diag mode on the console. In other words,
when you issue
> modemdiag
MODEMDIAG debug display is ON
>
you will start getting diag info dumped right to your screen, as soon
as there is any. I believe modemdiag output is only dumped as
modems hang up. So if no modems disconnect for 5 minutes, you won't
see any output for 5 minutes. Try using a different diag command
if you just want to see the output. For example, ">ether-display 0 64"
should spew all sorts of stuff at you....probably a lot more than
you want! ">ether-display 0 0" will stop it.
___________________________________________________________________________
Joe Pautler, E.I.T. University at Buffalo
CIT/OSS Network Engineering 224 Computing Center
http://www.oss.buffalo.edu/~pautler (716) 645-3536
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: