RE: (ASCEND) MAX 4048 and CT1

["Steven Copeland" <scopeland@pldi.net>]

Got it working!!!  After probing the DMS-10 for more information, finally
found out that it was actually sending me 7 digits which as most of you
probably know, the MAX doesn't like.  I guess the Cisco AS5300 box doesn't
care about digits.  Thanks for all your advice/suggestions.  I really
appreciated it.

Steven

-----Original Message-----
From: owner-ascend-users@max.bungi.com
[mailto:owner-ascend-users@max.bungi.com]On Behalf Of Steven Copeland
Sent: Tuesday, July 20, 1999 10:26 AM
To: ascend-users@bungi.com
Subject: (ASCEND) MAX 4048 and CT1


Hello everyone, I have problem that is about to drive me nuts.  I have a Max
4048 that I am trying to set for CT1 coming from a DMS 10 switch.  I
verified the circuit type (D4 AMI) is up and the channels are available.  I
have also set the "channel 1 slot=3" all the way down to channel 24.
However, when I dial into the max, I see the call hit one of the channels on
the max but I keep getting a fast busy.  What am I missing?  Any and all
help would be greatly appreciated.


**********************************************************
Thank You,
Steven Copeland

Senior Network Administrator/Internet Coordinator
Pioneer Internet - A service of Pioneer Long Distance, Inc.
Subsidiary of Pioneer Telephone Cooperative, Inc.
scopeland@pldi.net
405-375-0880
http://www.pldi.net
http://www.pld.net
http:/www.ptci.com

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>


++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>