Re: (ASCEND) P130 Password Prob

[Jim Logan <jim@top.net>]

Answered my own questions going back a bit further in the Archives (mine).
I had to load the 4.xxx flash first, then reboot --->> Editing of the
configuration could be done, then I could reload the ba.p13 load (Don't
know why they had loaded just b.p13 anyway?)

At 03:09 PM 7/23/1999 -0500, you wrote:
>
>Got a P130-UBRI-FT1 that know one knows the Full Access password for.
>Following the instructions exactly on Ascend's Web Site for NINDY, the unit
>still continues to boot up after removing the P1 Jumper with the old
>configuration settings.  What am I doing (not doing) wrong?
>
>My unit is the 1st version (JP1 is on left front corner), I am getting the
>correct boot screen with the jumper in place:
>
>Pipe50>
>
>Running ef, then df and getting upload (via Hyperterm - Xmodem) that looks
>complete of load b.p13 
>
>Then remove Jumper, repower up, same ole settings/passwords are still
>inplace??? 
>
>The current settings on the unit indicate Ver 5.0Ap1, load b.p13 (which is
>the same load I'm trying to reload to kill the current config/passwords).
>
>Anyone with ideas of why the new load isn't taking, and defaulting back to
>where I can configure the unit?  I've tried the normal full access
>password, and it don't take, so it was changed by the previous owner of the
>unit.
>
>Thanks for input - leaving Sunday for about 10 days, so would like to get
>this unit configured before then if I can.
>
> 
>******* Top Net InterNet Services ********
>Omaha, Nebraska                www.top.net
>            Voice: (402) 339-5609  
> 
>++ Ascend Users Mailing List ++
>To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
>To get FAQ'd:	<http://www.nealis.net/ascend/faq>
>
>
******* Top Net InterNet Services ********
Omaha, Nebraska                www.top.net
            Voice: (402) 339-5609  
 
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>