RE: (ASCEND) 2nd T1 on 6248...

["Troy Settle" <st@i-Plus.net>]

Net/T1 > Line Config > 10-100 (10-1**)

This is where you go.  If the telco configured the second PRI to be
identical to the first, then just compare the configurations of the 2 lines.

HTH,

Troy



** -----Original Message-----
** From: owner-ascend-users@max.bungi.com
** [mailto:owner-ascend-users@max.bungi.com]On Behalf Of Jim Jones, Jr.
** Sent: Tuesday, November 30, 1999 8:57 AM
** To: ascend-users@bungi.com
** Subject: (ASCEND) 2nd T1 on 6248...
**
**
** I have a 6248 and have had only one T1 plugged into it.  Now my customers
** are getting busy signals and we are adding a second T1.  When I got the
** 6248, it was configured by someone else and he disabled the second T1
** because it was not being used.  Now I need to re-enable it.
**
** Could someone point me in the right direction?  I have looked
** through most
** of the menus and did not see anything that looked like the right option.
**
** Thanks very much,
**
** Jim
**
** ++ Ascend Users Mailing List ++
** To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
** To get FAQ'd:	<http://www.nealis.net/ascend/faq>
**

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>