(ASCEND) after so many logins.. max6000 causes problems

["Henry Smith, Jr" <hensj@ihs2000.com>]

Having a bit of difficulty with our Max 6000.  It currently has 3 out 
of the 4  PRI's activated but once it reaches approximately 40 
customers dialed in..they get varied problems.  Most get 
720_no_protocols_configured, but if there is a sudden surge of people 
receiving those.. the max will log you in.. but hang you up instantly.

Once the usage goes down a bit.. everyone is fine.


therefore logins
================
40 and below.. no problems  (zero!)
41 to 42/46  receive the 720_no_protocols_configured error
while the 42-46 login attempts are processing, anyone after that... 
47+ will logins but be disconnected immediately.  Even though logins 
41-47 error out anyway..

At first I though the problem may have been with the third pri.. but 
I would then have to believe that the problem would only happen at 46 
connected users (23 per PRI * 2), but its not.

Looking at the configurations, the only thing that I noticed was that 
the time was an hour behind and the date was 1 day ahead.

Any suggestions on what I should be looking for and/or how to correct 
this problem would be of great help.  This is really starting to 
annoy us and our users.  We originally believed it was our users, 
because we would walk them through deleting the dialer, dialup 
adapter and tcp/ip and then readd them all.  This would work every 
time!  No shit!..  But further analysis seems to be that we were 
merely delaying there next attempt the login. Doing these steps was 
not fixing the problem.. only delaying them on the phone.. leaving 
time for the max 6000 to go below 40 again.  >DUH<   but hey... it 
was an honest mistake.

Again, any help desperately desired!

TIA
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>