RE: (ASCEND) Error on new TNT Ethernet Card

["Kevin McKee" <Kevin@northwestnt.com>]

My card is just an 8 port Ethernet card.  I've got two of them in the
box, and the first one has been working fine.  The second card is in a
perpetual RESET state, even after I reloaded the tntrel.tar file and
rebooted a  few times.  When the card is 'up' I get the following
message:
   LOG error, Shelf 1, Slot 17, Time:  00:49:52--
   Slot 1/3, timeout failure code=0 during  TIMEOUT
When I take it down ( slot -d 1 3 ), the error message goes  away.  I'm
running software 8.0.2
 
Can I assume this is a bad card?
 
The last time I called Ascend tech support, it took a full WEEK before
they  called me back.  And their knowledge level wasn't very high.  I'm
guessing I'll get a quicker answer from the people on this mailing list.
 
Thanks,
Kevin

	-----Original Message-----  
	From: Peter Lalor 
	Sent: Wed 6/14/2000 9:07 AM  
	To: ascend-users@max.bungi.com 
	Cc: Kevin McKee  
	Subject: Re: (ASCEND) Error on new TNT Ethernet  Card
	
	

	>From: "Kevin McKee"  <Kevin@northwestnt.com>
	>
	>I might be missing something  here, but I've  got a new
Ethernet-8 card
	>in our TNT, and I can't  get it to work.  I keep  getting the
following
	>error:
	>
	>LOG error, Shelf 1, Slot 17,  Time:  00:49:52--
	>   Slot 1/3, timeout failure code=0  during TIMEOUT
	>
	>I already have a functioning card of the  same type in the box.
A
	>'show' gives it's status as  'RESET'
	
	I don't know what an "Ethernet-8" card is, but are you running
a
	version of code that supports it? Do you have the image for
that
	particular card loaded? Do dircode for a list of what card
images  are
	loaded. You may need to load a new one for that  card.
	--
	
	Peter  Lalor           Infoasis
	plalor@infoasis.com   http://www.infoasis.com/
	
	"Where's  my burrito?" -- Homer
	

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>