Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) V.90 Code upgrade
At 08:22 AM 7/1/98 -0500, Rob Myers wrote:
>I have lately been considering uploading the new version of firmware (I
>believe 6.1.3 is the most current) on one of our Ascend Max 4000s. We
>currently have four Maxen in a hunt group, all of which are currently
>running 5.0Ap42.
If you are in a hunt group and only one has 56K modems in it, do you have
a separate dial-number for the one MAX?
>Only one of our Maxen has v.90-capable modems on it. The rest all have
>v.34-only modems. We would like to upload code on the Max with the
>v.90-capable modems and leave the others alone for the time being, since
>5.0Ap42 has been a very stable release for us.
I'm surprised that you have the V90 capable MAX in the same hunt group -
unless the hunt group is strictly data, and you have different numbers
for the V.34 versus 56K modems?
>We have OSPF and Stacking enabled between all four Maxen in the group.
>
>Each Max has four PRIs installed, two of which (in each box) are used for
>ISDN and two of which (in each box) are used for modems.
>
>Will it be possible to install the 6.1.3 or later code to get V.90
>capabilities on one box while leaving all the others alone and keeping
>OSPF and stacking between all boxes active?
Advice given elsewhere...I would agree that it is wise to separate this
MAX from the stack if possible.
Kevin Smith Ascend Communications...
Customer Satisfaction ...where Network Solutions never end.
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
Follow-Ups: