Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Dead Pipeline 50 -- How to reset?
At 12:54 1998/07/17 -0400, MyLink Ascend Admin wrote:
>it didn't come back up....just constantly brings up the power on Self
>Test and reboots...over and over.
>Now to the point, any ideas on how to fix this pipe without shelling out
>to ascend agin? Can I just open the unit up and clear some jumpers
>or something and reload a software rev through the serial port?
depends on the age of your unit:
if you have a round 6-pin power connector (AC)
then it is jumper J9 as listed in the FAQ:
http://www.nealis.net/ascend/faq/ascend-faq-q34.html
the last version of the P50 before the combined P50/P75
no toggle-switch version that ships now had that jumper
at the front of the board between the LEDs, probably labeled P1:
http://www.support.nl/lists/ascend/current/0028.html
If you can't find the right place, you can call me
at the number below, I've had to do it enough times...
-Jim H
----
Jim Howard Sr Network Engineer Lyceum Internet
jhoward@lyceum.com http://www.lyceum.com/ 404.248.1733
My PGP Public Key: http://www.lyceum.com/~jhoward/pgp-key.txt
Fingerprint: 7E8B E2BA 1314 2535 CB08 CFF9 119B 7CD3 2488 954D
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>