(ASCEND) Pipe75 NAT private IP

To: <ascend-users@bungi.com>
Subject: (ASCEND) Pipe75 NAT private IP
From: "Danko Jevtovic" <danko@sezampro.yu>
Date: Tue, 2 Jun 1998 20:17:30 +0200
Importance: Normal
In-reply-to: <Pine.LNX.3.95.980601044642.19930D-100000@babylon.erols.com>
Sender: owner-ascend-users@max.bungi.com

I have my first Pipe75 in testing on local LAN with dial-up connection to
Internet. I read about NAT problem (single address) and I am not sure if I
am experiencing it.

What debug command is used to show NAT translation tables and to clear
unneeded entries?

While reading manual again I have noticed recommendation for private IP
addres space to use all four decimal number with three digits (greater then
100 - xxx.xxx.xxx.xxx). I can not understand why is this important and what
is has to do with FTP protocol? I am using 10.0.0.201/24 for Pipe and I have
two more 10.0.n.x/24 classes on small local network.

Any information appreciated. Regards Danko Jevtovic, SezamPro On-Line system
administrator
mailto:danko@sezampro.yu http://www.sezampro.yu


++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

References:

(ASCEND) Wan Pool leak

From: Jason Nealis <nealis@babylon.erols.com>

Prev by Date: Re: (ASCEND) ShotGuns and other School Tools
Next by Date: Re: (ASCEND) 6.1.0 and Winsock.dll (version 2.0)
Prev by thread: (ASCEND) Restricted load: frame relay status?
Next by thread: Re: (ASCEND) restricted / extended loads = appology
Index(es):
- Main
- Thread