Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Re: NO Dialout with Max4000
Mr. Dana Hudes wrote:
> Ruediger,
> I have both 4030 (E1) and 4048 (T1) units, and while dialout
> works
> on the 4048 it does not on 4030. I reported this to technical
> support,
> its verified that the dialout code was "inadvertently (?) left
> out"
> of the E1 build. I use tbixk.m40 and ebixk.m40 respectively.
> Anyway, this is the case with 6.X code. It will be fixed, I was
> told,
> in the next build.
>
> Dana Hudes
> Graphnet
Hello Dana,i checked my used version:
it is
Software +6.0.7+
Load: fe.m40
Switched Installed
ISDN Sig Installed
and the module size 996592 Byte downloaded at May 19.
I can dialout over the S2m line and the loopback test works fine.
I have been told, that the Max4000 is like an Max2000 in a bigger case and
the second line should not work. (Is that you mentioned)
I cannot test this, because we use the Max4000
only with one S2m (30 channels). We never planned to use both.
regards, rf
--
+------------------------+---------------------------+
| Ruediger Fries | mailto: rf@ipw.net |
+------------------------+---------------------------+
| RDE Network Systems | phone: +49 611 95031-0 |
| ISP + PoP Wiesbaden | fax: +49 611 95031-555 |
| Kirchbornstrasse 2 | www1: http://www.ipw.net |
| D-65191 Wiesb./Germany | www2: http://www.rde.net |
+------------------------+---------------------------+
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: