(ASCEND) Resetting 4002 Passwords

[Steve Rivera <sales@wrca.net>]

I have a Ascend 4002.
Initially I was told by ascend that I would be able to short the memory, 
then access the
set parameters thru Navis. The unit did take the code, however I am still 
unable to reset the
memory.

This is what I was instructed to do, but it wont work on tthis unit. There 
arent enough jumpers for the procedure.
According to ascend  this procedure should work. However there is no J6, 
only J1,J2,J3.

Max4000
· With all cables and power removed remove all cards from the box, open the 
case
and
orient the LEDs toward you (the front).
· Locate P6 and short it.
· Attach the serial and power cables. Power up at 57600 N-8-1 no flow-control
· At the > prompt enter DF then upload the correct version of firmware. Down
load the
software using Xmodem 57600-N-8-1 no flowcontrol.
· Power down the unit, remove the jumper from P6 and put the cover back on
· Reconfigure the terminal/serial connection for 9600 and configure the 
Max, or
use theconfigurator.

Does anyone have a procedure for the 4002? I need to reset.
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>