Re: (ASCEND) 56k call routing in Max6000

["Alexander C. Pitzner" <pitzner@DPW.COM>]

Yes, I have (1) 16 port 56k modem card in port 3.  I need 56k access, ISDN
modem access, and ISDN dialout (dial backup to Cisco router).  I set a few
of the slot numbers in Net/T1 to slot 3.  Do I need to change the Prt/Grp
too?  I'm still getting a fast busy.  Again, modem card is not picking up.



At 09:32 PM 12/13/99 -0600, Jerry O'Brien wrote:
>Did you set the slot numbers in the Net/T1 line config to one of the slots
>holding a modem card?
>
>Jerry O'Brien	
>Network Administrator,
>CuttingEdge.net
>
>
>----- Original Message -----
>From: Alexander C. Pitzner <pitzner@DPW.COM>
>To: <ascend-users@max.bungi.com>
>Sent: Monday, December 13, 1999 2:09 PM
>Subject: (ASCEND) 56k call routing in Max6000
>
>
>> I have a Max 6000 running 7.0.22 w/ 1 16-port 56k modem card and 1
>> Host/Aim6 card (for v.25 bis dial backup).   When I call into the Max via
>> 56k modem, the call isn't routing to the 16port modem card.  I have the
>> answer # under the modem cards Mod Config.  I see the call come in as an
>> asterisk on the PRI line but it never gets to the modem card and then
>gives
>> me a fast busy signal.  I don't have trunk groups on under Sys Config.
>>
>> I can connect to a modem (Terminal server->open 3:1) and use at commands
>to
>> call out ok to another analog device.
>>
>> Am I having phone line problems, or is there something I'm missing?
>> Alex Pitzner
>> Davis Polk & Wardwell
>> Technical Support
>> (212) 450-5777
>> ++ Ascend Users Mailing List ++
>> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
>> To get FAQ'd: <http://www.nealis.net/ascend/faq>
>>
>
>
>
>
Alex Pitzner
Davis Polk & Wardwell
Technical Support
(212) 450-5777
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>