RE: (ASCEND) how to configure p75 dailing into max with multiple possilbe gw ip;'s

["Troy Settle" <st@i-Plus.net>]

Ok,

Go into the Configure menu (right from the top), and set the Rem
Addr=192.168.100.100

This should automagically find it's way into the default route setting as
well.  Go check it.

Now, when you connect, this address will obviously be wrong, but the pipe
will set those values termporarily to the IP address of the peer, and
everything will work.  Magic.

HTH,

Troy

PS: I pulled that right out of a pipe-75 that one of my customers uses to
connect to one of our several maxen.



> -----Original Message-----
> From: owner-ascend-users@max.bungi.com
> [mailto:owner-ascend-users@max.bungi.com]On Behalf Of Laurence Kahn
> Sent: Friday, January 14, 2000 22:04
> To: ascend-users@max.bungi.com
> Subject: (ASCEND) how to configure p75 dailing into max with multiple
> possilbe gw ip;'s
>
>
>
>
> I cannot figure out how to configure my p75 to dial into my isps
> new maxs which have rollover
> so the default gateway could be one of serveral ip addresses.. If
> I remove the default static route
> from the routing table after connecting ok to the max (leaving
> all ip addresses in the config as 0.0.0.0) no default gateway is
> ever established so routing does not work..
>
> If I put the default static route in and am lucky enough to get
> the max with that ip on dialup
> all works ok.. how can I get this to work..
>
> in the past I either needed a static route or put in a real ip
> address for the rem addr field
> since I was connection to another pipeline..
>
> thanks in advance
> ++ Ascend Users Mailing List ++
> To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd:	<http://www.nealis.net/ascend/faq>
>

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>