Real Time Ascend Maling List Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Urgent help required- Possible Bad Max 4000
The Serial Speed is not 9600.. When it boots up it ALWAYS set itself to 9600
when booting up and
then changes to the speed specified in the setup of the Max when the system
starts.
Just Change the serial speed to 38400,57600 or other until you find the
right speed.
Thanks
Craig Whitmore
iGRIN Internet
----- Original Message -----
From: Raymond Brighenti <bargi@webfront.net.au>
To: <ascend-users@bungi.com>
Sent: Wednesday, June 07, 2000 12:40 PM
Subject: (ASCEND) Urgent help required- Possible Bad Max 4000
> Hi,
>
> We have just purchased a Max4000HP, I hooked it up via the console port
and
> get the below results, the box will just sit and continue to reset itself
> bringing up the same thing. I have tried pulling the modem cards out and I
> still get the same thing.
>
> Any ideas on what the problem is and if it is fixable?
>
>
> UART initialized
> extended load:
> inflate essential
> .+..+.........................................................
>
> inflate expendable ...|...|......
> starting system...
> yom9%/۽K _
> {i{{ 'sgggg gggggg
> O! -
> !! q"eg!?=A !!!q
> ..!>!!!! C! !!!C!!!!! !!!!!!!!!!!!!!!
> !!! ! !!! !!!!! !!!!?!!!!!!- C!!!!!
> !
> ! !!!!.{{"7_
>
{{{3[i{{{K1g{{mg'g
> {{{3[i{{{K1g{{mg'g{{s
> gggC{{s7g{g
> {[{8g{{{sggi'q
s[9?9g1[99[9[9F)?
>
>
>
> ============================================
> "In cases of major discrepancy it's always reality
> that's got it wrong....reality is frequently inaccurate."
> ============================================
>
> ++ Ascend Users Mailing List ++
> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd: <http://www.nealis.net/ascend/faq>
>
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>