(ASCEND) Pipeline NAT + Real IP's: possible?

[Brian <signal@shreve.net>]

We have a customer we want to setup with NAT and a Real IP subnet of say
208.242.78.0/29.

So we setup the P130 just like you would normally for NAT, using
192.168.1.0/24 as their network, and .1 assigned to the ethernet
interface.

We also assigned 208.242.78.1/29 to the ethernet secondary.  then added a
static route entry for destination 208.242.78.1/29 with a gateway of
208.242.78.1.

This seems to work in that it routes between 192.168.1.0/24 and
208.242.78.1/29.  All IP's seem to get translated when going out to the
Internet though.

Is it possible to run Real IP's and NAT at the same time so you can say,
put some servers on a /29 and then use RFC1918 space for like workstations
on a /24?  Or am I in some sort of pipe dream? (no pun intended).

Brian


-----------------------------------------------------
Brian Feeny (BF304)     signal@shreve.net   
318-222-2638 x 109	http://www.shreve.net/~signal      
Network Administrator   ShreveNet Inc. (ASN 11881) 	      

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>