Re: (ASCEND) Pipeline NAT + Real IP's: possible?

[Phillip Vandry <vandryp@psi.ca>]

Pipeline NAT does not have this functionality.

-Phil

> We have a customer we want to setup with NAT and a Real IP subnet of say
> 208.242.78.0/29.
> 
> So we setup the P130 just like you would normally for NAT, using
> 192.168.1.0/24 as their network, and .1 assigned to the ethernet
> interface.
> 
> We also assigned 208.242.78.1/29 to the ethernet secondary.  then added a
> static route entry for destination 208.242.78.1/29 with a gateway of
> 208.242.78.1.
> 
> This seems to work in that it routes between 192.168.1.0/24 and
> 208.242.78.1/29.  All IP's seem to get translated when going out to the
> Internet though.
> 
> Is it possible to run Real IP's and NAT at the same time so you can say,
> put some servers on a /29 and then use RFC1918 space for like workstations
> on a /24?  Or am I in some sort of pipe dream? (no pun intended).
> 
> Brian
> 
> 
> -----------------------------------------------------
> Brian Feeny (BF304)     signal@shreve.net   
> 318-222-2638 x 109	http://www.shreve.net/~signal      
> Network Administrator   ShreveNet Inc. (ASN 11881) 	      
> 
> ++ Ascend Users Mailing List ++
> To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd:	<http://www.nealis.net/ascend/faq>
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>