(ASCEND) Radius User Question

[Scott Stavretis <scott@mail.cdi.com.au>]

Hello,

Im currently uses Livingston radius with our Ascend gear.
RADIUS version 2.0 96/10/30  NDBM PASSCHANGE flat_users

On a standard user entry I want it to only allow connections if the dial
in on certain numbers. 

IE.  How do I get the following user to only connected of the numbers the
dialed were either 5551111 5552222 5553333 5554444

I presume this can be done by checking 
Called-Station-Id = "5551111" 
or whatever but not sure how.

This is a common setup we use.

username   Auth-Type = System
        Service-Type = Framed-User,
        Framed-Protocol = PPP,
        Framed-IP-Address = 255.255.255.254,
        Framed-MTU = 1500
        Idle-Timeout = 0
        Session-Timeout = 0

Regards
Scott Stavretis
Connect Direct Internet
---- www.cdi.com.au ----

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>