Re: (ASCEND) Enabling IPX on a MAX 4000

["Joe Max" <max_and_tnt@hotmail.com>]

You need to do two things:
* in Ethernet/ModConfig/EtherOptions, set the IPX parameters for your 
ethernet.
* set Ethernet/ModConfig/IPX Routing=Yes.

After you set those parameters, Answer/PPP Options should allow you to set 
IPX parameters. I don't know if a reset is required but I always do it when 
enabling a new protocol just in case.


>From: Stephen Mulrine <skm@foremost.co.uk>
>To: ascend-users@bungi.com
>Subject: (ASCEND) Enabling IPX on a MAX 4000
>Date: Wed, 19 Apr 2000 11:34:16 +0100
>
>I loaded fek.m40 (7.0.26) onto our MAX 4030 and expected IPX to be enabled,
>but Route IPX still says N/A under Ethernet -> Answer -> PPP Options, and
>the other IPX settings say N/A as well.  Is there something else I need to
>do?  Previously we've only been routing IP.  It's presumably the correct
>software load as the unit suddenly started requesting IPX routes from our
>hacked RADIUS server.
>
>Cheers,
>Stephen
>++ Ascend Users Mailing List ++
>To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
>To get FAQ'd:	<http://www.nealis.net/ascend/faq>

______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>