Re: (ASCEND) Does TNT 2.1.0 upgrade really need config restore?

["Kevin A. Smith" <kevin@ascend.com>]

At 12:35 PM 6/2/98 -0700, Peter Lalor wrote:
>In the "MAX TNT TAOS 2.1.0 Release Note 3" under" Installing the TAOS 2.1.0
>software" it says:
>
>Upgrading a system running 2.0.0 or later
>admin> load tar network host-1 tntrel.tar
>6 Reset.
>7 Restore the configuration you saved in Step 2. For example:
>admin> load config network host-1 cfgsave
>
>After resetting, the TNT comes up fine, apparently with the config intact.
>I did not restore the config again, per Step 7. Can someone at Ascend
>confirm if (and why) this is really needed? If so, should you restart a
>second time after restoring?

To avoid plagiarizing....

>The answer to this is NO.  The save/restore is precautionary.  In general,
>the restore is not necessary.
>
>vikki


Kevin Smith			Ascend Communications...
Customer Satisfaction	...where Network Solutions never end.

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

---

References:

• (ASCEND) Does TNT 2.1.0 upgrade really need config restore?
• From: Peter Lalor <plalor@infoasis.com>

---

• Prev by Date: Re: (ASCEND) ASCEND EUROPEAN SALES/MAINTENANCE SUPPORT
• Next by Date: (ASCEND) Bonding multi-2Mbs Fastway links?
• Prev by thread: (ASCEND) Does TNT 2.1.0 upgrade really need config restore?
• Next by thread: (ASCEND) 6.1 and OSPF routing
• Index(es):
  • Main
  • Thread