Real Time Ascend Maling List Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) MAX 4002 won't link to PRI
No - I connected 2 to 4 and 1 to 5, which is what
Ascend said to do - although that doesn't necessarily mean they're right.
Now, I need to do some checking to see which it is.
At 03:17 PM 4/17/2000 -0700, you wrote:
>Did you make the loopback cable going from pin 1 to pin 4 and pin 2 to
>pin 5? If so, then you might be right that it's a bad CSU.
>
>
>When I made a loopback cable and hooked it to the WAN1 port, I got a
>solid
>Red Alarm - as opposed to RA/YA/S1 back and forth every few seconds
>which
>is what it was doing when hooked to the telco. It should have been
>showing that it
>was in loopback mode. Ascend said this is a bad CSU, so it's off as an
>RMA now.
>
>++ Ascend Users Mailing List ++
>To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
>To get FAQ'd: <http://www.nealis.net/ascend/faq>
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>