Re: (ASCEND) MAX 4002 won't link to PRI

["Peter Copeland" <Tharen@i-t-c.com>]

I just checked my book - you're right about the pinout. Ascend was wrong.
However, even with the cable set 1 to 4 and 2 to 5,
the display still shows Red Alarm, so I'll still return it as
an RMA.


At 03:17 PM 4/17/2000 -0700, you wrote:
>Did you make the loopback cable going from pin 1 to pin 4 and pin 2 to
>pin 5?  If so, then you might be right that it's a bad CSU.
>
>
>When I made a loopback cable and hooked it to the WAN1 port, I got a
>solid
>Red Alarm - as opposed to RA/YA/S1 back and forth every few seconds
>which
>is what it was doing when hooked to the telco. It should have been
>showing that it
>was in loopback mode. Ascend said this is a bad CSU, so it's off as an
>RMA now.
>
>++ Ascend Users Mailing List ++
>To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
>To get FAQ'd:	<http://www.nealis.net/ascend/faq>

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>